- Follow Detect And Zero Rightmost One on WordPress.com
-
Recent Posts
Archives
- December 2022
- August 2022
- July 2022
- August 2021
- May 2021
- February 2020
- July 2019
- June 2019
- March 2019
- February 2019
- January 2019
- November 2018
- September 2018
- August 2018
- July 2018
- June 2018
- January 2018
- November 2017
- October 2017
- August 2017
- July 2017
- May 2017
- April 2017
- March 2017
- February 2017
- January 2017
- November 2016
- August 2016
- July 2016
- June 2016
- April 2016
- February 2016
- January 2016
- October 2015
- July 2015
- June 2015
- May 2015
- October 2014
- August 2014
- May 2014
- January 2014
- November 2013
- September 2013
- August 2013
- March 2013
- February 2013
- January 2013
- December 2012
- October 2012
- September 2012
- August 2012
- July 2012
- June 2012
- May 2012
- April 2012
Categories
Meta
Monthly Archives: August 2014
Fifth Print – getting Better
I completed my 5th print using the QU-BD One Up 3D printer. It is getting good enough to do something useful. This print was another Suburu logo because I wanted to get that right before trying something harder. This time … Continue reading
QU-BD One-Up’s First Attempt at printing
After, many, many stumbles, I attempted my first print. It was going well, at first, and then the filament stopped feeding. The QU-BD One-Up’ filament feed is quite crude, with minimal tensioning capability. There are folks with fixes posted on … Continue reading
Current State of QU-BD One-Up 3D Printer project
UPDATE: The current state of my QU-BD One-Up 3D Printer project is that the printer is finished but I am having problems with the preferred host software, Repetier. After assembly there was a significant gantry sag. The One-Up gantry is … Continue reading