Category Archives: 3D Printing

Fifth Print – getting Better

I completed my 5th print using the QU-BD One Up 3D printer. It is getting good enough to do something useful. This print was another Suburu logo because I wanted to get that right before trying something harder. This time … Continue reading

Posted in 3D Printing | Tagged , | 1 Comment

QU-BD One-Up’s First Attempt at printing

After, many, many stumbles, I attempted my first print. It was going well, at first, and then the filament stopped feeding. The QU-BD One-Up’ filament feed is quite crude, with minimal tensioning capability. There are folks with fixes posted on … Continue reading

Posted in 3D Printing | Tagged , | 1 Comment

Current State of QU-BD One-Up 3D Printer project

UPDATE: The current state of my QU-BD One-Up 3D Printer project is that the printer is finished but I am having problems with the preferred host software, Repetier. After assembly there was a significant gantry sag. The One-Up gantry is … Continue reading

Posted in 3D Printing, Electronics, hardware, Linux | Tagged , | Leave a comment